Skip to content

Cassette and chainring wear

Reviewed on November 17, 2026

The gears wear because the chain drags on them. Every tooth takes a share of your pedal force on every turn. That's a lot of contact over a season.

Cassette, chainring, sprocket

The cassette is the stack of gears on the rear wheel. The chainring is the big gear at the pedals. Wikipedia and some makers say "sprocket" for any toothed gear the chain runs on, so you'll see that word too.

The usual cause

A worn chain is the usual driver. Park Tool says wear can cause the chain to mesh poorly with cogs and chainrings, causing poor shifting and premature wear to the cogs.1 Wikipedia says the longer link spacing can result in increased wear on the sprockets.2

The road.cc piece says the same, and adds that keeping an eye on chain wear is how to protect the gears.3

How the gears wearChain links grow longerChain meshes poorlyTeeth wear unevenlyChain skips under load
The chain sets the pace for the rest.

What a worn cassette looks like

Don't expect it to be obvious. SRAM's Chris McKenney, quoted in the road.cc piece, says changes in tooth shapes and skipping under load are signs that your cassette needs replacing.3 He adds that the shape changes are hard to see until they're well past the end of the part's life.3

Wikipedia describes extreme cases: the teeth wear unevenly and may even become hook-shaped.2 When the sprockets reach that point, skipping may continue even after the chain is replaced.2

What you'd feel is a pedal stroke that suddenly goes light for a moment, then catches. It tends to happen when you push hard, like starting uphill.

What a worn chainring looks like

SRAM says chainring teeth slowly take on the shape of a shark's fin in use. It says the roughness is the clue: if you see daylight between the teeth and a new chain, the chainrings are likely worn.3

SRAM also says an inner chainring is considered worn when a clean new chain starts to "chain suck," where the chain doesn't release well at the bottom of the ring. An outer chainring is considered worn when it runs very roughly or the shifting is poor or inconsistent. It adds that it's somewhat of a judgment.3

Quick comparison

Part Signs the sources describe
Cassette Changed tooth shape, skipping under load3
Chainring Shark's fin teeth, daylight between teeth and a new chain3
Both Poor or imprecise shifting1

What to do with the information

A worn chain and worn gears often go together, so checking the chain first is the usual order. See measuring chain wear. If the gears look or feel worn too, the replacement timing page covers what the makers say.

Gear parts differ by bike. Follow the bike or drive maker's manual for the right parts.

Sources used

  1. When to Replace a Worn Chain, Park Tool
  2. Bicycle chain, Wikipedia
  3. Are your chainrings and cassette worn? Here's how to tell when they need replacing, road.cc