Skip to content

Measuring chain wear: what the makers' tools and charts say

Reviewed on November 17, 2026

You can't judge chain wear by eye. A worn chain looks like a normal one. So makers sell small gauges, and there's a cheap ruler check too.

The ruler check

Park Tool calls this a ballpark method. Pick a rivet and line it up with the zero mark. Count 24 more rivets, and the last one should land on the 12 inch mark. If it's off by more than 1/16 inch, Park Tool says the chain is stretched to the point of replacement.1

Wikipedia lists the ruler as one way to measure wear.2 It's rough. Reading a tiny gap on a ruler is easy to get wrong.

Gauges

Park Tool says the easiest and most accurate way to find chain wear is a chain wear indicator tool.1 Wikipedia describes the common type: a tool with a tooth about the size of one on a sprocket. You set it on the chain under light load, and if the tooth drops in all the way, the chain should be replaced.2

Park Tool's CC-3.2 works like a go/no-go gauge. You hook one end on a roller, then try the other end in the chain. If it goes in, the chain is now 0.5 percent longer than when it was new. Flip the tool for the 0.75 percent end.1

Park Tool says that if the 0.5 end doesn't go in, the chain isn't yet 0.5 percent worn.1

Checking a chain with a gaugeClean the chainHook the gauge on a rollerTry the other end in the chainCompare with your maker's limit
The same idea applies to most drop-in gauges.

The limits the makers give

The percentage is how much longer the chain has become compared with new. Park Tool's general guidelines depend on how many gears the bike has.3

Drivetrain Replace at or just before
Single-speed3 1.0%
5 to 10 speeds3 0.75%
11 to 13 speeds3 0.5%

Those are general numbers from a tool maker. Park Tool itself says many drivetrain manufacturers have unique recommendations for their own parts, so always double-check.3 It also says every drivetrain maker has its own specifications and to consult the manufacturer for your system.1

On an e-bike, that means looking up the chain or drive maker's number. The bike's manual or a dealer can tell you where to find it.

Keep it simple

Pick one tool and use it the same way each time. Park Tool's CC-4.2 contacts the chain in three places, and says you need to keep tension on the short section of chain for an accurate reading.1 Read your own tool's instructions for the exact steps. Write the reading down with the date. That's it.

A chain that reads past its limit is a prompt to act. The next question is what a worn chain does to the cassette and chainrings, and when makers say to replace parts together.

Sources used

  1. When to Replace a Worn Chain, Park Tool
  2. Bicycle chain, Wikipedia
  3. CC-4.2 Chain Checker, Park Tool